hilscher NXHX 52-JTAG, Начало работы

Страница: 54 / 89

Step By Step Instructions for Typical Use Cases 54/89
NXHX 52-JTAG | Getting Started
DOC131004GS02EN | Revision 2 | English | 2013-11 | Released | Public
© Hilscher 2013
4. Configure NXHX board for DPM host interface mode.

Set the S2 Host Mode switch on the NXHX board (see position in
Device Drawing and Positions of the NXHX 52-JTAG chapter on page
12) to Parallel Dual-Port Memory 16 bit mode .
If you are using an NXHX 52-JTAG board hardware revision 2 , use
the following settings:
S2 SW Setting
1 off
2 on
3 off
4 on
5 on
6 on
Table 6: Set Parallel Dual-Port Memory 16 Bit Mode at Switch S2 for Hardware Revision 2

If you are using an NXHX 52-JTAG board hardware revision 3 , use
the following settings:
S2 SW Setting
1 off
2 off
3 off
4 on
5 on
6 on
Table 7: Set Parallel Dual-Port Memory 16 Bit Mode at Switch S2 for Hardware Revision 3

Use the S1 switch on the NXHX board (see position in Device
Drawing and Positions of the NXHX 52-JTAG chapter on page 12) to
set the boot strap options to FLASH boot mode . Use the following
settings:
S1 SW Setting
1 off
2 off
3 off
4 off
5 off
6 on
7 off
8 off
Table 8: Set Flash Boot Mode at Switch S1