Step By Step Instructions for Typical Use Cases
31/89
NXHX 52-JTAG | Getting Started
DOC131004GS02EN | Revision 2 | English | 2013-11 | Released | Public
© Hilscher 2013
The Bootwizard loads the ELF file.
Figure 23: ELF File Loaded
3. Set parameters.
In
the
Chip type
area, select
51/52
.
In
the
Bootblock parameters
area, open the first drop-down list next to
Source device
and select
Serial flash on SPI bus
entry.
Open the right drop-down list and select
Generic SPI Flash netX51/52,
10MHz
entry.
Note:
Because Quad SPI Flash is used on the NXHX 52-JTAG board, the
setting you choose in the right drop-down list of the
Source device
parameter is actually of no consequence. However, any one of these
entries must be selected; otherwise the
Generate boot image
button will
not be enabled.
In the first drop-down list next to
Dest. device
, make sure that
SDRAM
is selected. Open the right drop-down list and select
SDRam MT48LC2M32B2-7IT
entry.
4. Specify output file.
In
the
Output
area, click
Save as
button.
The
Select the output file
dialog window opens.
In the
File name
field, specify file name of the executable binary file
which you want to create (the
*.bin
Boot Image), e. g. “example.bin”.
Specify the output directory, then click
Save
button.
