Introduction
5/75
1
Introduction
1.1
About this document
1.1.1
Description of the contents
This user manual describes hardware, installation and commissioning of
the LAN controlled Hilscher
netHOST
master devices for fieldbus and Real-
Time Ethernet networks:
NHST-T100-DP/DPM
for PROFIBUS DP (order no.: 1890.410/DPM)
NHST-T100-CO/COM
for CANopen (order no.: 1890.500/COM)
NHST-T100-DN/DNM
for DeviceNet (order no.: 1890.510/DNM)
NHST-T100-EN/PNM
for PROFINET IO (order no.: 1890.840/PNM)
NHST-T100-EN/ECM
for EtherCAT (order no.: 1890.110/ECM)
NHST-T100-EN/EIM
for EtherNet/IP (order no.: 1890.820/EIM)
NHST-T100-EN
for PROFINET IO, EtherCAT or EtherNet/IP
(order no.: 1890.800, hardware and performance are identical to the
NHST-
T100-EN/PNM/ECM/EIM
devices, but
firmware has to be loaded into the
device by the customer)
This document also features the technical data of the devices and of the
supported network protocols. Instructions for resetting a netHOST device to
its “factory settings” (firmware recovery) are also provided here.
The installation of the configuration software and the configuration of the
netHOST devices are not subject of this document.
The installation of the software is described in the user manual
Software
Installation netHOST Devices
. Instructions on how to configure, diagnose
or test a netHOST device, or how update its firmware are provided in the
operating instruction manual
Configuration of LAN controlled master
devices
–
netHOST
.
All devices are delivered with their firmware already installed, except for the
NHST-T100-EN
netHOST device. If you are using the
NHST-T100-EN
, you
will find instructions on how to install the firmware in the operating
instruction manual
Configuration of LAN controlled master devices
–
netHOST
.
See also section
netHOST NHST-T100 | LAN controlled master devices
DOC130401UM05EN | Revision 5 | English | 2018-05 | Released | Public
© Hilscher 2013 – 2018
