Safety
22/154
PC Cards cifX PC/104 | Installation, Operation and Hardware Description
DOC120206UM42EN | Revision 42 | English | 2014-12 | Released | Public
© Hilscher, 2008-2014
2.5 Safety Instructions to avoid Property Damage
To avoid property damage respectively device destruction to the PC card
cifX and to your system, you necessarily must read, understand and follow
the following safety instructions and safety messages in this manual about
danger causing property damage, before you install and operate your PC
card.
2.5.1
Device Destruction by exceeding allowed Supply Voltage
To avoid device destruction due to high supply voltage to your PC card
cifX, you must observe the following instructions. These instructions apply
to all PC cards cifX described in this manual.
The PC card cifX may only be operated with the specified supply voltage.
Make sure that the limits of the allowed range for the supply voltage are not
exceeded. A supply voltage above the upper limit can cause severe
damage to the PC card cifX! A supply voltage below the lower limit can
cause malfunction in the PC card cifX. The allowed range for the supply
voltage is defined by the tolerances specified in this manual.
The data on the mandatory supply voltage for the PC cards cifX described
in this manual you find in the
Power Supply and Host
Interface on page
28. There the required and permitted supply voltage is provided by device
type inclusively the permitted tolerance range.
2.5.2
Device Destruction by exceeding allowed Signaling Voltage
To avoid device destruction due to high signal voltage to your PC card cifX,
you must observe the following instructions. These instructions apply to all
PC cards cifX described in this manual.
All I/O signal pins at the PC card cifX tolerate only the specified signaling
voltage!
Operation with a signaling voltage other than the specified signaling
voltage may lead to severe damage to the PC card cifX!
The data on the mandatory signaling voltage for the PC cards cifX
described in this manual you find in the section
Power Supply and Host
Interface
on page 28. There the required and permitted signaling voltage
is provided by device type.
