Hill-Rom CareAssist P1170, Руководство по обслуживанию

Страница: 37 / 197

Physical Description
Chapter 1: Introduction
CareAssist™ Bed Service Manual (man330) Page 1 - 23
1
Table 1-8. Electromagnetic Emissions Guidance
Table 1-9. Electromagnetic Immunity Guidance
Guidance and Manufacturer's Declaration—Electromagnetic Emissions
The CareAssist™ Bed model P1170 is intended for use in the electromagnetic environment specified below. The customer
or the user of the model P1170 should make sure it is used in such an environment.
Emissions Test Compliance Electromagnetic Environment—Guidance
RF emissions
CISPR 11 Group 1 The model P1170 uses RF energy only for its internal
functions. Therefore, its RF emissions are low and are
not likely to cause any interference in nearby electronic
equipment.
RF Emissions
CISPR 11 Class A The model P1170 is suitable for use in all establishments
other than domestic and those directly connected to the
public low-voltage power supply network that supplies
buildings used for domestic purposes.
Harmonic Emissions
IEC 61000-3-2 Not Applicable
Voltage Fluctuations/
Flicker Emissions
IEC 61000-3-3 Not Applicable
Guidance and Manufacturer's Declaration—Electromagnetic Emissions
The CareAssist™ Bed model P1170 is intended for use in the electromagnetic environment specified below. The customer
or the user of the model P1170 should make sure it is used in such an environment.
Immunity Test
IEC 60601
Test Level
Compliance Level
Electromagnetic
Environment—Guidance
Electrostatic
Discharge (ESD)
IEC 61000-4-2 ± 6 kV Contact
± 8 kV Air ± 6 kV Contact
± 8 kV Air Floors should be wood, concrete, or
ceramic tile. If floors are covered
with synthetic material, the relative
humidity should be at least 30%.
Radiated RF
IEC 61000-4-3 3 Vrms
80 MHz to 2.5 GHz 3 Vrms
80 MHz to 2.5 GHz Portable and mobile RF communica-
tions equipment should not be used
at close distances to the P1170 bed.
(See Note 2)
Electrical Fast
Transient/Burst
IEC 61000-4-4 ± 2 kV on Power Supply
Lines
± 1 kV on Input/ Output
Lines ± 2 kV on Power Supply
Lines
± 1 kV on Input/ Output
Lines Mains power quality should be that
of a typical commercial or hospital
environment.
Surge
IEC 61000-4-5 ± 1 kV Differential Mode
(Line-Line)
± 2 kV Common Mode
(Line-Ground) ± 1 kV Differential Mode
(Line-Line)
± 2 kV Common Mode
(Line-Ground) Mains power quality should be that
of a typical commercial or hospital
environment.