Hill-Rom CareAssist P1170, Руководство по обслуживанию

Страница: 104 / 197

4.8 Foot Section Motor
Chapter 4: Removal, Replacement, and Adjustment Procedures
Page 4 - 24 CareAssist™ Bed Service Manual (man330)
4.8 Foot Section Motor
Tools required: 13 mm socket
Ratchet
Extension
E-ring installation tool
Removal
1. Set the brakes.
2. Raise the sleep surface to the highest position.
3. Raise the head section to the highest position.
4. Remove the seat and knee sections.
SHOCK HAZARD:
Unplug the unit from its power source. Failure to do so could result in
personal injury or equipment damage.
5. Unplug the unit from its power source. Let the unit to sit for 60 seconds for
the battery to time out.
6. Remove the two screws (A) and washers (B) securing the power supply
cover (C) to the power supply (D) (see figure 4-12 on page 4-25).
7. On the power supply P.C. board, disconnect the foot section motor
connector (number 2).
8. Remove the cable cover on the central rail and remove the foot section
motor cable.
9. Remove the foot section motor cable from the bed.
10. Remove the E-ring (E) from the rod end pin (F) (see figure 4-13 on page
4-25).
11. Remove the E-ring (G) from the motor end pin (H).
12. Remove the pin (F) and two plastic spacers (I).
NOTE:
Note the position of the plastic spacers for installation later.
13. Remove the motor end pin (H).