5. Select the Address Type as IP Address or Domain Name.
6. Enter IP address or domain name according to the address
type.
7. Enter the port number for the protocol.
Note
The port number of the wireless network and wired network
should be consistent with the port number of EHome.
8. Select the Protocol Type as EHome.
9. Set an account name for the network center.
10. Click Save.
Set Device Capture Parameters
You can configure the capture parameters of the access control
device, including manual capture and event triggered capture.
Note
• The capture function should be supported by the device.
• Before setting the capture parameters, you should set the
picture storage first to define where the event triggered
pictures are saved. For details, refer to Set Picture Storage in
the user manual of the client software. .
Set Triggered Capture Parameters
When an event occurs, the camera of the access control device
can be triggered to capture picture(s) to record what happens
when the event occurs. You can view the captured pictures when
checking the event details in Event Center. Before that, you need
to set the parameters for the capture such as number of pictures
captured for one time.
Before You Start
Before setting the capture parameters, you should set the picture
storage first to define where the captured pictures are saved. For
details, refer to Set Picture Storage in the user manual of the
client software.
Steps
Note
This function should be supported by the device
1. Enter the Access Control module.
2. On the navigation bar on the left, enter Advanced Function →
More Parameters → Capture .
3. Select an access control device in the device list and select
Linked Capture.
4. Set the picture size and quality.
5. Set the capture times once triggered which defines how many
pictures will be captures for one time.
6. If the capture times is more than 1, set the interval for each
capture.
7. Click Save.
Set Manual Capture Parameters
83
