ID5000 Series Smart Code Reader User Manual
47
Figure 8-24 Set and Execute Software Trigger Mode
Steps
1. Click
I/O Control Settings
→
Input
→
Trigger Mode
.
2. Select
On
as
Trigger Mode
.
3. Select the specific line as
Trigger Source
according to actual demands.
4. Set
Debounce Time
and
Line Out Trigger In Polarity
according to actual demands.
Note
●
When selecting
Rising Edge
or
Falling Edge
as
Line Out Trigger In Polarity
, you can set
Trigger
Delay
.
●
When selecting
Level High
or
Level Low
as
Line Out Trigger In Polarity
, you can set
Start Delay
Time
and
End Delay Time
according to actual demands.
Figure 8-25 Set and Execute Hardware Trigger Mode
Set and Execute Counter Trigger Mode
Counter specifies that the trigger source will be generated after the set number of valid signals
appears. For example, if you set the
Count Number
to
3
, the trigger source will be generated after
3 signals appear.
Steps
1. Click
I/O Control Settings
→
Input
→
Trigger Mode
.
2. Select
On
as
Trigger Mode
.
Содержание ID5000 Series
