HIKOKI G 1813DE, Инструкция по эксплуатации

Страница: 41 / 68

English
41
8. Keep the tool’s terminals (battery mount) free of swarf and dust.
○ Prior to use, make sure that swarf and dust have not collected in the area of the
terminals.
○ During use, try to avoid swarf or dust on the tool from falling on the battery.
○ When suspending operation or after use, do not leave the tool in an area where it
may be exposed to falling swarf or dust.
Doing so could cause a short circuit that could result in smoke emission or
ignition.
PRECAUTIONS FOR BATTERY AND CHARGER
1. Always charge the battery at an ambient temperature of -10–40°C. A temperature of
less than -10°C will result in over charging which is dangerous. The battery cannot
be charged at a temperature greater than 40°C.
The most suitable temperature for charging is that of 20–25°C.
2. Do not use the charger continuously.
When one charging is completed, leave the charger for about 15 minutes before
the next charging of battery.
3. Do not allow foreign matter to enter the hole for connecting the rechargeable
battery.
4. Never disassemble the rechargeable battery or charger.
5. Never short-circuit the rechargeable battery.
Short-circuiting the battery will cause a great electric current and overheat. It
results in burn or damage to the battery.
6. Do not dispose of the battery in fi re.
If the battery is burnt, it may explode.
7. Using an exhausted battery will damage the charger.
8. Bring the battery to the shop from which it was purchased as soon as the post-
charging battery life becomes too short for practical use. Do not dispose of the
exhausted battery.
9. Do not insert objects into the air ventilation slots of the charger.
Inserting metal objects or fl ammable into the charger air ventilation slots will result
in an electrical shock hazard or damage to the charger.
CAUTION ON LITHIUM-ION BATTERY
To extend the lifetime, the lithium-ion battery equips with the protection function to stop
the output.
In the cases of 1 to 3 described below, when using this product, even if you are pulling
the switch, the motor may stop. This is not the trouble but the result of protection
function.
1. When the battery power remaining runs out, the motor stops.
In such case, charge it up immediately.
2. If the tool is overloaded, the motor may stop. In this case, release the switch of tool
and eliminate causes of overloading. After that, you can use it again.
00Book̲G1810DE̲ChS.indb 41 00Book̲G1810DE̲ChS.indb 41 2022/08/26 16:37:25 2022/08/26 16:37:25