HIKOKI G 1813DE, Инструкция по эксплуатации

Страница: 57 / 68

English
57
4. Use proper grinding angle.
Grind only with the wheel’s edge by lifting the
grinder 15° to 30°, as shown in Fig. 16 .
CAUTION
Do not use the entire surface of the depressed
center wheel. Use only the edge of the
depressed center wheel.
5. Move the grinder in the proper direction.
When using a new depressed center wheel in direction A ( Fig. 16 ), the wheel edge may cut
into the workpiece. In this case, grind in direction B ( Fig. 16 ). Once the wheel edge is worn,
the workpiece can be ground in both directions.
NOTE
The wheel provided (resinoid wheel) is rated as Class A grain and # 36 grain size. It is most
suitable for heavy grinding of steel and other types of materials.
6. Adjust operation to desired fi nish.
For a fi ne fi nish, decrease pressure by lifting slightly. Grind slowly and at the appropriate
speed.
CAUTION
The revolving depressed center wheel will create air turbulence.
Do no lay the grinder down in areas of dust or dirt until it has come to a complete
stop.
ASSEMBLING AND DISASSEMBLING THE DEPRESSED
CENTER WHEEL (Fig. 17)
WARNING
Be sure to turn o ff the switch and pull out the battery.
1. Assembling
(1) Turn the disc grinder upsidedown so that the spindle is facing upward.
(2) Align the across fl ats of the wheel washer (A) (G1810DE, G1810DF) or the wheel
washer (C) (G1813DE, G1813DF) with the notched part of the spindle, then attach them.
(3) Fit the protuberance of the depressed center wheel onto the wheel washer (A) or (C).
(4) Screw the wheel nut onto the spindle.
(5) While pushing the push button with one hand, lock the spindle by turning the depressed
center wheel slowly with the other hand.
Tighten the wheel nut by using the supplied wrench as shown in Fig. 17 on page 58.
A B
15°–30°
Fig. 16
00Book̲G1810DE̲ChS.indb 57 00Book̲G1810DE̲ChS.indb 57 2022/08/26 16:37:28 2022/08/26 16:37:28