HIKOKI G 1813DE, Инструкция по эксплуатации

Страница: 47 / 68

English
47
○ Overload protection
While working, if a load exceeding a certain level is applied, or if the grinding disc is
stopped for a certain amount of time, the motor will be stopped to protect the tool and for
safety.
Turn o ff the switch once, then turn it on again to start up the tool.
○ Rotation recovery control function
While working, if the tool is pressed too forcefully against the surface and the motor stops, if
you lift up the tool and lighten the load, rotation will resume.
Depending on the grinding disc used and the working conditions, the rotation recovery
control may be stopped by overload protection.
○ Overheat protection
This protection feature cuts o ff the power to the motor and stops the power tool in the event
of overheating of motor during operation.
When the overheat protection feature has been activated, the motor may stop.
In this case, release the tool switch and cool it down in a few minutes.
After that you can use it again.
○ Restart prevention function
When the power is still switched on, the tool will not restart when a battery is installed. This
function can be canceled once the tool is switched o ff .
○ Brake function
Brake activates when the switch is o ff .
CHARGER
Model UC18YSL3
Charging voltage 14.4 V–18 V
Weight 0.6 kg
00Book̲G1810DE̲ChS.indb 47 00Book̲G1810DE̲ChS.indb 47 2022/08/26 16:37:26 2022/08/26 16:37:26