HighLine RCH Hydro, Руководство оператора

Страница: 53 / 101

Section 4 - Operating the Mower
7. Lower to the cutting height.
The mower shall not be operated
without the chain guards in place
or in good condition.
- Use the hydraulic lever (or joystick if
installed) to lower the deck to the
preferred cutting height.
- Operate at a sufficient height that
prevents the blades from striking the
ground or cutting the edge of the
ditch, which increases blade wear and
causes undue strain on the system.
- Install height stops around the height
cylinder rod to maintain the preferred
height.
8. Adjust ground speed for the terrain, the
type, height and density of vegetation and
the cutting height.
The mower shall not be operated without
the side plate skid shoes in place.
- Recommended speed is between 2
and 5 mph (3 - 8 kmh)
- Decrease the ground speed as the
severity of the cutting condition's
increase and to permit grasses to
partially rebound from the tires.
- The mower can cut vegetation up to
3½" (89mm) in diameter for short
periods of time.
Note: If the mower is cutting too much
material, the hydraulic pressure
will exceed safe limits. At that point
a pressure relief valve will be
activated which will cause the
blade pan to stop turning.
Once the pressure relief valve has been
activated (shown by blade pans not
turning), raise the mower decks to allow
the pressure relief valve to close and to
recover the blade pan RPM.
Set the Cutting Height
214112
Adjust Ground Speed
214113
Page 4-10