HighLine Bale Pro CFR651, Руководство оператора

Страница: 46 / 77

Section 4 - Operating the CFR 651
2. Set the speed of the feeder chain.
Set the direction of the feeder chain so
that the chain bars move toward the flail
drum. This will keep the bale against the
flails and rotate the bale. It will also cause
the bottom of the bale to move against
the flail guard rods.
Adjusting the feeder chain speed will
influence the discharge rate and the time
to process a bale.
-
Adjust the feeder chain speed using
the hydraulic flow control.
Recommended Speed Range:
10 - 25 chain revolutions per minute.
Chain Speeds
- Faster feeder chain speeds (at the
same aggression level setting) will
result in a faster discharge of material.
- Slower feeder chain speeds (at the
same aggression level setting) will
result in a slower discharge of
material.
Loose Material Build Up
- If loose material builds in the tub:
-
slow down the feeder chain to
allow the flail drum to process the
material.
- slow down the feeder chain to
avoid removing material with the
feeder chain.
- To remove loose material buildup,
reverse the feeder chain for a short
time and then restore the direction of
moving the bottom of the bale towards
the flail drum.
Set Feeder Chain Direction and Speed
216100
Page 4-3