Higen FDA5000 Series, Руководство по эксплуатации

Страница: 58 / 168

Chapter 4. Digital Loader Operation
4- 8
4.4 Changing Parameters
The parameter value can be changed in the same method.
Even though the changeable range varies according to menu, operation methods are the same.
Hence, [Motor ID (P1-01)] is presented here as a representative example.
Motor ID
P1-01 11
Motor ID
P1-01 1 2
Motor ID
P1-01 1 2
Motor ID
OK? 1 2
Motor ID
P1-01 1 1
ENTER
PROG
ENTER
Cursor indicates changable position
Cussor position value increases 1 at a
time by the use of UP, and decreases
1 at a time by the use of DOWN
Cursor moves to left by the use of LEFT
and to right by the use of RIGHT
Upon editing, press ENTER to terminate
editing. When the parameter change
message is displayed, verify changed
parameter by ENTER key. IF PROG is
pressed, previous parameters are
maintained wiyhout using the changed
parameters.
Motor ID
P1-01 1 2
PROG
PROG
Starts parameter editing and cancels parameter change
ENTER
Verifies changed parameter
Increases or decreases cursor position value
Moves cursot to left or right