NGS Mach II User Guide v1.1
PATS Functions
38
Reprogramming After a PCM Module Replacement
Anytime a PCM Module is replaced, it is necessary to set up communications between the PCM and
PATS function module. Follow the instructions carefully to ensure the proper settings.
IMPORTANT!
Make sure to read Ford’s TSB 01-6-2 for important information
before
replacing any PATS related modules.
Special Note
If you are replacing the module make sure to do the following:
• Disconnect the battery before removing the module.
• Verify the ignition key is in the OFF position before reconnecting the battery.
Before You Begin
Make sure the vehicle hookup and NGS Mach II setup are completed. If not, complete before continuing.
Accessing Vehicle Information
Using the vehicle’s shop manual:
1. Make sure you have the correct model and year for the vehicle you are programming.
2. Cut additional keys if necessary.
3. Note the Module that contains PATS functionality.
4. Check the PATS type to continue to the proper instructions:
• PATS I • PATS II
Procedure for PATS I Systems with SCIL or PATS Module
Because the PATS function is retained when replacing the PCM, no additional programming is required.
Procedure for PATS II Systems with PCM Module
Because the original keys can be programmed to the replacement PCM, please use the procedures for
. For new PCMs, simply cycle two keys.
