Hensel-Visit Expert D 1000, Руководство пользователя

Страница: 47 / 76

Operating the device
47
Activating and deactivating the photo cell
To activate and deactivate the photo cell, proceed as follows:

Press the SLAVE button.
The LED display above the SLAVE button lights up green.

Press the SLAVE button again.
The LED display above the SLAVE button goes out. The photo cell is
deactivated.
The flash is triggered through the photo cell by the striking of a flash
emitted by another device. The photo cell functions as a pulse photo
cell. It works only if the light output of the emitted flash is stronger
than the available light. For this reason, you must ensure that
excessively strong extraneous light does not affect the photo cell. In
such cases, the flash must be triggered either using the sync cord or
the radio remote trigger.
Radio remote trigger
The device has a built-in radio receiver “Strobe Wizard Plus” and freemask
system. With the optionally available radio remote trigger, the camera and
flash can be synchronized via radio signal. To set the radio channels,
proceed as follows:

Briefly press the RC button.
The LED display lights up green. The radio receiver is activated.

To select the channel, press the RC button or rotary switch for approx. 2
seconds.
The channel that was last set appears on the display.

Using the rotary switch, set the desired radio channel within 3 seconds.
Approx. 3 seconds after the last entry, the set radio channel is saved and
the display no longer flashes.

Please also observe the instructions of the radio remote trigger.
After the H.C1, H.C2 and H.C3 radio channels of the HENSEL “Strobe
Wizard Plus” radio remote trigger system, the H.F1, H.F2 and H.F3
radio channels for the HENSEL freemask system appear.