Henny Penny OFG-391, Руководство оператора

Страница: 39 / 70

Model OFG- 391
3-12. FILTER PUMP MOTOR The filter pump motor is equipped with a manual reset button,
located on the rear of the motor, in case the motor overheats. Wait
about 5 minutes before attempting to reset this protective device to
allow motor to cool. Remove the access panel on the left side
panel of the unit to reset the button. It takes some effort to push the
reset, and a screwdriver can be used to help reset the button.
To prevent burns caused by splashing shortening, turn
the unit’s main power switch to the OFF position before
resetting the filter pump motor’s manual reset protec-
tion device.
Figure 3-3
3-13. CLEANING THE FRYPOT After the initial installation of the fryer, as well as before every
change of shortening, the frypot should be thoroughly
cleaned as follows:
1. Turn the COOK/PUMP switch to OFF, and unplug unit
from wall receptacle.
Moving the fryer or filter drain pan while containing
hot shortening is not recommended. Hot shortening can
splash out and severe burns could result.
The filter drain pan must be as far back under fryer
as it will go, and the cover in place. Be sure the hole in
the cover lines up with the drain before opening the
drain. Failure to follow these instructions causes
splashing of shortening and could result in personal
injury.
2. If hot shortening is present in the frypot, it must be drained by
slowly pulling the drain handle out towards you.
3. Close the drain valve and discard the shortening.
4. Raise lid, remove the racks and carrier from lid, and tilt lid
back, so that the lid won’t interfere with cleaning.
703 3-19