Henny Penny OFG-391, Руководство оператора

Страница: 31 / 70

Model OFG- 391
3-7. BASIC OPERATION 4. Allow fryer to heat until illuminates.
(Continued)
Bypass the Melt Cycle, if desired, by pressing a product
button and holding it for five seconds. The display shows
“EXIT MELT? 1=YES 2=NO”. Press to exit melt.
In the event of a power failure, no attempt should be made to
operate the fryer. The fryer is equipped with an automatic
ignition system and cannot be operated without electrical
power.
Do not bypass the Melt Cycle unless enough shortening
has melted to completely cover all of the burner tubes.
If the Melt Cycle is bypassed before all buner tubes
are covered, excessive smoking of shortening, or a fire
could result.
The heat cycles on and off about 10 degrees before the
setpoint temperature, to help prevent overshooting the
setpoint temperature. (proportional control)
Once out of the Melt Cycle, flashes until 5° before setpoint
temperature is reached. Then illuminates and the selected
product shows in the display.
5. Before loading product onto the racks, lower the racks
into the hot shortening to prevent the product sticking to
the racks.
6. Slide racks of breaded product into carrier on the lid,
starting with the bottom rack, to prevent damaged product.
7. Lower and latch the lid, and press .
A different product can be selected during the first minute of
cooking, in case the wrong product button was pressed. To
check the shortening temperature press or to stop a
Cook Cycle, press .
8. At the end of the cycle, an alarm sounds, while the display
shows “DONE”. Then press .
703 3-11