Henny Penny OE-100, Техническое руководство

Страница: 5 / 51

1-1
Model OE-100
SECTION 1. TROUBLESHOOTING
1-1. INTRODUCTION
This section provides troubleshooting information in the form of
an easy-to-read table.
If a problem occurs during the first operation of a new fryer,
recheck the installation per Section 2 of the Operator Manual.
Before troubleshooting, always recheck the operating procedure
per Section 3 of the Operator Manual.
1-2. TROUBLESHOOTING In the event of a control system failure, the digital display will
show an "Error Message". These messages are coded E4, E5, E6,
E41, E50, E51, and E53. The following table will assist you in
troubleshooting possible malfunctions within the unit:
E4 Control too hot Turn switch to OFF position, then turn
switch back to POWER position. If display
shows E4, heating circuits, insulation, and
fan should be checked. (See Section 2-19.)
E5 Shortening too hot Unplug unit, or turn off circuit breaker to
unit. If display still shows E5, heating and
high limit circuits should be checked per
Section 2-5 and Section 2-6.
E6 Temperature probe failure Unplug unit, or turn off circuit breaker to
unit. If display still shows E6, check tempera-
ture probe connection at board. If connection is
good, replace temperature probe.
E10 High temperature limit failure Reset high temperature limit by manually
pushing on lever, behind door. (see Figure
3-2 of the Operator Manual). If high limit does
not reset, replace high limit per Section 2-5.
E41, E50, Control errors Unplug unit, or turn off circuit breaker to
E51, E53 unit. If display still shows an error, re-
initialize the control (see Section 4-4 of
Operator Manual). If error still persists,
change the control board.
Display Cause Correction
294