Henny Penny OE-100, Техническое руководство

Страница: 10 / 51

2-4
Model OE-100
409
2-5. HIGH TEMPERATURE
LIMIT CONTROL
(Continued)
Before following these steps, place POWER switch in the
OFF position and unplug the power cord or open the wall
circuit breaker.
1. If the tube is broken or cracked, the control will open, shutting off
electrical power. The control cannot be reset.
Use replacement high limit, part no. 16337, 420 degree.
2. Drain shortening from the frypot.
3. Remove control panel per Section 2-3.
4. Remove the retainer securing the silicone gasket.
5. Loosen small inside screw nut on capillary tube.
6. Remove capillary bulb from bulb holder inside the frypot.
7. Straighten the capillary tube.
8. Remove larger outside nut that threads into pot wall.
9. Remove the two nuts that hold the high limit bracket from control
panel area.
10. Lift defective control from control panel area.
11. Insert new control and replace nuts to bracket.
12. Uncoil capillary line, starting at capillary tube, and insert through
frypot wall.
To avoid electrical shock or other injury, the capillary line
must run under and away from all electrical power wires
and terminals. The tube must never be in such a position
where it could accidentally touch the electrical power
terminals.
13. Carefully bend the capillary bulb and tube toward bulb holder on
heating elements.
14. Slip capillary bulb into bulb holder located on heating elements.
Pull excess capillary line from pot and tighten nut into frypot wall.