Henny Penny MPC-1L, Техническое руководство

Страница: 11 / 26

Model MPC-1L, MPC-22, MPC-554
2-2 Oct. 2018 FM06-038-B
2-4. PROGRAMMING
DESCRIPTIONS
Description Action
1. °F/°C Press the UP/DOWN button to toggle the mode.
2. Int/USA Press the UP/DOWN button to toggle between International and
Domestic Unit.
3. Unit Type
(554/222/21L/22/1L)
Press the UP/DOWN button to toggle between the Unit Types.
4. Set point for top heater Press the UP/DOWN button to increment/decrement the set point value.
5. Set point for bottom heater Press the UP/DOWN button to increment/decrement the set point value.
6. Set point for side heater Press the UP/DOWN button to increment/decrement the set point value.
7. CPU temperature Press UP/DOWN button to view highest board temperature.
The actual board temperature displays.
8. Outputs test 1. Use the DOWN button to toggle the heat outputs on/off.
2. Use the UP button to move on to the next step.
3. Use the DOWN button to toggle each of the other three heaters ON/
OFF.
4. Use the
UP
button to advance to the next step.
The display will show which heater is being tested as follows: OP-
1 , top heater. OP-2 , bottom heater. OP-3 , side heater.
“ OP-0 ” displays with no heater outputs on and “ OP-A ” displays
when all the heater outputs are on.
9. Initialization “ InI ” displays.
1. Press and hold the UP/DOWN button to initialize the control back to
defaults.
The display counts down “ In-3 ”, “ In-2 ”, In-1 ”, and then “ InI ”, “
SyS ”, “ donE ”.
2. Release
UP/DOWN
when “
InI
”, “
SyS
” displays.
Control is now initialized.
3. Wait 2 seconds before turning off power after initialization.
Always press the P button to advance to the next step.
Press and hold the P button at any time to exit Special Programming mode.