Important: Always read and follow the instructions.
•
23
Installation Instructions
A factory trained COATS
®
Service Technician must
perform the install, setup, and initial test procedures
on your wheel balancer. Do not attempt to install and
setup the unit yourself. Accurate and reliable operation
of your unit depends on proper installation. Please con-
tact COATS
®
directly at 1-800-688-9240 for the
Certified Service Partner nearest you.
Receiving
The shipment should be thoroughly inspected as
soon as it is received. The signed bill of lading is
acknowledgement, for the carrier, of receipt in good
condition of the shipment covered by our invoice.
If any of the goods called for on this bill of lading are
shorted or damaged, do not accept them until the car-
rier makes a notation of the shorted or damaged goods
on the freight bill. Do this for your own protection.
NOTIFY THE CARRIER AT ONCE if any hidden loss or
damage is discovered after receipt and request him to
make an inspection. If the carrier will not do so, pre-
pare an affidavit to the effect that you have so notified
the carrier (on a certain date) and that he has failed to
comply with your request.
IT IS DIFFICULT TO COLLECT FOR LOSS OR DAM-
AGE AFTER YOU HAVE GIVEN THE CARRIER A CLEAR
RECEIPT.
File your claim with the carrier promptly. Support your
claim with copies of the bill of lading, freight bill,
invoice, and photographs, if possible.
Although COATS responsibility ceases upon delivery
of the shipment to the carrier, we will gladly assist in
tracing lost shipments. Our willingness to assist in
every possible manner does not make COATS respon-
sible for collection of claims, or replacement of lost or
damaged materials.
Standard Accessories
•
Built-in Weight Tray
•
3 Back Cones (A, B, C)
•
Truck Cone (D)
•
Hub Nut
•
Pressure
Cup
•
Rim Width Calipers
Features
• Balances Most Automotive Wheels
• Single-Spin Dynamic Two-Plane or Static Balancing
• Vertical Wheel Mounting
• Back Cone and Front Cone Mounting
• “No Bolt-Down” Installation
• Scratch Resistant Control Panel
• Easy-To-Read LEDs and Displays
• Automatic Calibration
• Removable Shaft Stud
• Automatic Rim Gauge Return
• Dynamic, Static, and Alloy Operating Modes
Specifications
130 lbs.
115V, 50/60 Hz, 3A
IP 54
0.8 Kw
< 130 rpm
• Cycle time for average wheel (14 kg) 6-8 seconds
0.10 oz
± 1.4 °
< 70dB (A)
0 - 252 mm
1.5 to 20 inches
• Weight (excluding adapter)
• Single-phase power supply
• Protection class
• Max power consumption
• Balancing speed
• Max.resolution of measurement
• Position resolution
• Average noise
• Rim-machine distance
• Rim width setting range
• Diameter setting range
10 to 30 inches
Electrical Requirements
See serial tag for the appropriate power requirements
of your machine.
Always have a qualified electrician install the proper
receptacles in accordance with state and local codes.