HENNESSY INDUSTRIES Coats 885, Инструкции по безопасности, Инструкции по установке, Инструкции по эксплуатации, Инструкции по обслуживанию

Страница: 28 / 32

Err. 11 Speed too high error
During unbalance measurement rotation,
wheel speed is more than 270 rpm
Err.14 /
Err.15 /
Err.16 /
Err.17 /
Err.18 /
Err.19
Unbalance measurement error
Err. 20 Wheel still. The wheel must remain still
for more than one second after START
Err. 21 Motor on for more than 15 seconds
Err. 24 Distance between the spokes less than
18 degrees
Err. 25 Distance between the spokes greater
than 120 degrees
Err. 26 First spoke too far from the
unbalance
Err.230÷238 Operating touch monitor errors
Err. 240 Machine setting error
Unbalance
incorrect
with back
centring
cones
Mount the wheel in vertical position and
push the sleeve up against the wheel. If
necessary, repeat locking/unlocking/
locking and perform the procedure again
▪
Check in self-diagnostics that the encoder functions properly
▪ Replace the computer board
▪
Check in self-diagnostics that the encoder functions properly
▪
Check detection unit connections
▪
Verify machine earth/ground connection
▪
Mount a wheel with more or less known unbalance (less than 100
g) and verify he response of the machine
▪
Replace the computer board
▪
Use the self-diagnostics function to check the encoder
▪ Check the connections on the power board
▪
Replace the computer board
▪ Use the self-diagnostics function to check the encoder
▪
Check the connections on the power board
▪ Replace the computer board
▪
The minimum distance between the spokes where the unbalance
is to be split must be greater than 18 degrees
▪
Repeat the SPLIT function increasing the distance between
the spokes
▪
The maximum distance between the spokes where the unbalance
is to be split must be less than 120 degrees
▪
Repeat the split function increasing the distance between the
spokes
▪ The maximum distance between the unbalance position and
the spoke must be less than 120 degrees
▪ Repeat the split function increasing the distance between the-
spokes and the unbalance
▪
Restart the balancing machine
▪
Calibrate the touch monitor
▪
Check touch monitor connections
▪
Replace the touch monitor
▪
Execute the initialization function
▪ Mount the wheel in vertical position and push the sleeve up
against the wheel. If necessary, repeat locking/unlocking/locking
and perform the procedure again.
Important: Always read and follow the instructions.
2 2
•