Evolution™ Electric Bed LI156Ex
40
QD1532A(2)
USER MANUAL
A
C
C
ESSO
R
IES
5.11 OXYGEN CYLINDER HOLDER (
AC959A-AD101A-
AD102A
)
Safe Working Load: 15 Kg
(1)
The oxygen cylinder holder is designed to accept an oxygen cylinder and
must only be fitted on the patient helper supports at the head-end of the bed
outside the sleep surface. It can be rotated by approximately 90°. Each
holder corresponds to one type of cylinder and must never be used for a
different cylinder model.
AC959A for cylinder
model B5 (Ø140)
AD101A for cylinder
model D (Ø100)
AD102A for cylinder
model E (Ø100)
The
following
recommendations
are
designed to prevent any possible incidents
so that this accessory can be used in optimum
safety conditions for both the patient and nursing
staff.
Check that cylinder is correctly positioned at the
base of the Cylinder holder.
Never use a different oxygen cylinder model from the model that is specified
above (danger of dropping or interfering with various operations).
Pay close attention to the position of the Cylinder Holder (particularly if it is
under the Head Section) when setting the Trendelenburg/Reverse Trendelenburg
positions or when lowering the sleep surface.
Ensure that the Cylinder Holder is not allowed to fall when raising a siderail.
Prevent any impact when moving a bed equipped with a Cylinder
Holder to another room (especially doorways). If the Cylinder
Holder does not allow the bed to go through a doorway, position
the holder in front of the bed, otherwise place it and the cylinder
on the mattress (remember to put the holder in its normal
position after moving the bed).
(1)
Safe Working Load for the I.V pole, allowing for a substantial safety margin.
