Heise PTE-2, Руководство по эксплуатации и обслуживанию

Страница: 13 / 88

11
The operator can program several parameters in the
calibrator which are further detailed in this manual.
Programmable parameters include:
• Date and time
• Owner name
• Auto off time
• Port selection
• Select Voltage (v) or current (mA) monitoring
• Enable/Disable 24VDC power supply
• Zero modules
• Tare
• Damping
• Percent error function
• Engineering units select
• User defined unit of measure
• Dual sensor mode
• Pressure or Temperature switch test mode
• Calibration of base unit
• Module calibration
• Datalogging via USB
• Datalogging to internal memory
• Transfer datalog to SD card
Owner name and base unit calibration functions are password
protected. The passwords may be obtained by contacting the
factory or downloading the “HHC Secure” application from the
web site. “HHC Secure” will generate the HHC’s unique pass
codes based on user input of the base unit serial number. Make
a note of these pass codes
Owner Pass code_______________________________
Calibration pass code _________________________________
Quick-select modules are available for measuring a wide variety
of pressure and temperature ranges. They can be “hot swapped”
within the base unit while it is powered on without causing any
damage to the base unit or the module. “Hot Swap” refers to
installing or removing modules while the base unit is powered on.
The base unit will recognize the module and display the
unit of measure in which the module was originally calibrated
and labeled. Quick-Select pressure modules are available in
accuracies from ±0.1% to ±0.025% of span.
SECTION 5 HOW TO OBTAIN PROGRAMMING
PASSCODES
SECTION 6 QUICK-SELECT MODULE
OVERVIEW
SECTION 4 BASE UNIT OVERVIEW CONT.
USB PORT SD CARD PORT
USB MICRO B
CONNECTOR