Heise PTE-2, Руководство по эксплуатации и обслуживанию

Страница: 47 / 88

45
SECTION 15 j. RTD TEMPERATURE
MEASUREMENT CONT.
To select RTD probe characteristics
Install an RTD Quick-Select Module and Probe in the HHC
Base Unit.
Press MENU key
Use DOWN or UP ARROW to highlight “Setup…”
Press ENTER
Use DOWN or UP ARROW to highlight “Module…”
Press ENTER
Use DOWN or UP ARROW to highlight “RTD…”
Press ENTER
RTD Module programming screen will appear
Use DOWN or UP ARROW to highlight “Channel”…
Press ENTER
Use DOWN or UP ARROW to highlight “CH1” “CH2”
Press ENTER
Note: If the incorrect type of module is installed a “MODULE
ERROR” message will be shown.
Return to RTD Module screen
Use DOWN or UP ARROW to highlight “Probe connection…”
Press ENTER
Use DOWN or UP ARROW to highlight “2-wire…”, “3-wire…”,
or “4-wire…”
Press ENTER
Return to RTD Module screen
Use DOWN or UP ARROW to highlight “Probe select…”
Press ENTER
Use DOWN or UP ARROW to highlight “Probe 01 through
08…” (per table above)
Press ENTER
Return to RTD Module screen
Use DOWN or UP ARROW to highlight “Resolution…”
Press ENTER
Use DOWN or UP ARROW to highlight “1”, “0.1”, ”0.01”or
“0.001”
Press ENTER
Return to RTD Module screen
Use DOWN or UP ARROW to highlight “Apply”
Press ENTER
Programmed settings are saved to memory and HHC returns to
Measurement Mode with RTD operating as programmed above.
RTD Module
Channel…
Probe connection…
Probe Select…
Resolution…
Apply
–0.017
PSi degF
77.9