Heinzmann Programmer 2, Руководство пользователя

Страница: 50 / 57

7 Error Handling
44
Programmer PG 02
3060 ErrAmplifier 3160 SErrAmplifier
Cause: Overload, overtemperature at amplifier .
Response: - Error message.
Actions: - Restart governor by reset.
- Notify HEINZMANN.
Note: These parameters are implemented only in the HELENOS series.
3060 ErrFeedbackAdjust2 3160 SerrFeedbackAdjust2
Cause: Automatic calibration of the actuator 2 could not be performed, wrong input
of reference values for actuator.
Response: - Governor cannot be put into operation.
Actions: - Check voltage supply and supply lines to actuator 2.
- Check feedback cable to actuator 2.
- Check actuator 2, replace actuator 2 if necessary.
- Engine stop switch must be opened (indication parameter 2810
Switch-
EngineStop
= 0) to perform automatic calibration of actuator 2 with 2-
quadrant-operation.
- Check reference values and error limits for feeedback
- Programme feedback error limits
1962
FeedbackErrorLow
= 0
1963
FeedbackErrorHigh
= 65535
store values ( ↑
3.2 Saving Data
)
, restart governor by reset and repeat
automatic calibration.
- Set error limits again.
Note: These parameters are implemented only in the PRIAMOS III series.
3061 ErrFeedbackAdjust3 3161 SerrFeedbackAdjust3
Cause: Automatic calibration of the actuator 3 could not be performed, wrong input
of reference values for actuator.
Response: - Governor cannot be put into operation.
Actions: - Check voltage supply and supply lines to actuator 3.
- Check feedback cable to actuator 3.
- Check actuator 3, replace actuator 3 if necessary.
- Engine stop switch must be opened (indication parameter 2810
Switch-
EngineStop
= 0) to perform automatic calibration of actuator 3 with 2-