HEIDENHAIN TNC 620 E, Руководство пользователя

Страница: 723 / 840

Test Run and Program Run | Program run
18
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
723
Resuming program run after an interruption
The control saves the following data during a program interruption:
The last tool that was called
Current coordinate transformations (e.g., datum shift, rotation,
mirroring)
The coordinates of the circle center that was last defined
The control uses the stored data for returning the tool to
the contour after manual machine axis positioning during an
interruption (
RESTORE POSITION
soft key).
Operating notes:
The saved data remains active until it is reset (e.g.,
by selecting a program).
If you interrupt an NC program using the
INTERNAL STOP
key, then you must start machining
at the start of the program or by using the
BLOCK SCAN
function.
For program interruptions within program section
repeats or subprograms, re-entering at the point of
interruption must be done using the
BLOCK SCAN
function.
With machining cycles, mid-program startup is
always executed at the start of the cycle. If you
interrupt a program run during a machining cycle, the
control repeats machining steps already carried out
after a block scan.
Resuming the program run with the NC Start key
You can resume program run by pressing the machine
START
button if the program was interrupted in one of the following ways:
Press the
NC Stop
key
Programmed interruption
Resuming program run after an error
With an erasable error message:
Remove the cause of the error
Clear the error message from the screen: Press the
CE
key
Restart the program, or resume program run where it was
interrupted