HEIDENHAIN TNC 620 E, Руководство пользователя

Страница: 662 / 840

Manual Operation and Setup | Using a 3-D touch probe (option 17)
16
662
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
Writing measured values from the touch-probe cycles
to the preset table
If you want to save measured values in the basic
coordinate system, use the
ENTRY IN PRESET TABLE
function. If you want to save measured values
in the workpiece coordinate system, use the
ENTER IN DATUM TABLE
function.
Further information: "Writing measured values from
the touch probe cycles to a datum table", page 661
With the
ENTRY IN PRESET TABLE
soft key, the control can write
the values measured during any probe cycle in the preset table.
The measured values are then stored referenced to the machine
coordinate system (REF coordinates). The preset table has the
name PRESET.PR, and is saved in the TNC:\table\ directory.
Select any probe function
Enter the desired coordinates for the preset in the designated
input boxes (depends on the touch probe cycle being run)
Enter the preset number in the
Number in table?
input field
Press the
ENTRY IN PRESET TABLE
soft key
The control opens the
Overwrite active preset?
menu.
Press the
OVERWRITE PRESET
soft key
The control saves the preset in the preset table under the
entered number.
Preset number does not exist: The control saves the row
only after pressing the
CREATE LINE
(Create line in table?)
Preset number is protected: Press the
ENTRY IN LOCKED LINE
soft key to overwrite the active
preset
Preset number is password-protected: Press the
ENTRY IN LOCKED LINE
soft key and enter the password to
overwrite the active preset
The control displays a note if a table row cannot be
written to because of disabling. The probing function
itself is not interrupted.