HEIDENHAIN TNC 620 E, Руководство пользователя

Страница: 632 / 840

Manual Operation and Setup | Moving the machine axes
16
632
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
Selecting the axis to be moved
You can activate the principal axes X, Y, Z and three other axes
defined by the machine manufacturer directly through the axis
keys. Your machine tool builder can also place the virtual axis VT
directly on one of the free axis keys. If the virtual axis VT is not on
one of the axis keys, proceed as follows:
Press the handwheel soft key
F1
(
AX
)
The control shows all active axes on the handwheel display. The
currently active axis flashes.
Select the desired axis with the handwheel soft keys
F1
(
->
) or
F2
(
<-
) and confirm with the
F3
(
OK
) handwheel soft key
Setting the handwheel sensitivity
The handwheel sensitivity determines which path an axis takes per
revolution of the handwheel. The sensitivity levels are predefined
and are selectable with the handwheel arrow keys (only when
incremental jog is not active).
Selectable sensitivity levels:
0.001/0.002/0.005/0.01/0.02/0.05/0.1/0.2/0.5/1 [mm/revolution or
degrees/revolution]
Selectable sensitivity levels:
0.00005/0.001/0.002/0.004/0.01/0.02/0.03 [in mm/revolution or
degrees/revolution]
Moving the axes
To activate the handwheel, press the handwheel
button on the HR 5xx:
Now you can operate the control only via the
HR 5xx. The control displays a pop-up window
with this information on the screen.
Select the desired operating mode with the
OPM
soft key if necessary
If required, press and hold the permissive button
Use the handwheel to select the axis to be
moved. Select the additional axes with the soft
keys as required
Move the active axis in the positive direction
with the
+
key, or
Move the active axis in the negative direction
with the
-
key
To deactivate the handwheel, press the
handwheel key on the HR 5xx
Now you can operate the control via the
operating panel again.