HEIDENHAIN TNC 620 E, Руководство пользователя

Страница: 691 / 840

Manual Operation and Setup | Tilting the working plane (option 8)
16
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
691
The control uses the following transformation types for
tilting:
COORD ROT
if a
PLANE
function was previously executed with
COORD ROT
after
PLANE RESET
with corresponding configuration of the machine
parameter
CfgRotWorkPlane
(no. 201200) by the
machine tool builder
after starting the control
after switching the kinematics
after running the cycle
19 WORKING PLANE
TABLE ROT
if a
PLANE
function was previously executed with
TABLE ROT
with corresponding configuration of the machine
parameter
CfgRotWorkPlane
(no. 201200) by the
machine tool builder
after starting the control
after switching the kinematics
after running the cycle
19 WORKING PLANE
If tilting was active when the control was turned off,
then the control also moves in the tilted working plane
when it is turned on again.
Further information: "Crossing the reference point in a
tilted working plane", page 623
To deactivate manual tilting
To deactivate, set the appropriate operating modes to
Inactive
in
the
Tilt working plane
menu.
Even if the
3D-ROT
dialog in the
Manual operation
mode is set
to
Active
, resetting the tilting (
PLANE RESET
) with an active basic
transformation still functions correctly.