HEIDENHAIN TNC 620 E, Руководство пользователя

Страница: 710 / 840

Test Run and Program Run | Showing the workpiece blank in the working space (option 20)
18
710
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
18.2 Showing the workpiece blank in the
working space (option 20)
Application
In the
Test Run
operating mode, you can graphically check the
position of the workpiece blank and the preset in the working
space of the machine. The graphics show the preset that has been
set in the NC program using Cylce 247. If you have not set a preset
in the NC program, then the graphics show the active preset on the
machine.
You can active workspace monitoring in the
Test Run
operating
mode: to do so, press the
BLANK IN WORK SPACE
soft key. You can
activate or deactivate the function using the
SW limit monitoring
soft key.
A transparent cuboid represents the workpiece blank. Its
dimensions are shown in the
BLK FORM
table. The control takes
over the dimensions from the workpiece blank definition of the
selected program.
For a test run it normally does not matter where the workpiece
blank is located within the working space. If you activate
workspace monitoring, you must graphically shift the workpiece
blank so that it lies within the working space. Use the soft keys
shown in the table.
You can also activate the current preset for the
Test Run
operating
mode.
Soft keys Function
Shift workpiece blank in positive/negative X
direction
Shift workpiece blank in positive/negative Y
direction
Shift workpiece blank in positive/negative Z
direction
Show workpiece blank referenced to the set
preset
Display the current traverse range
This shows the traverse ranges config-
ured by the machine tool builder and can be
selected accordingly.
Switch monitoring function on or off
Display machine reference point