Hedensted Gruppen HG Combi Cut, Руководство пользователя

Страница: 42 / 55

Telephone 0045 75891244
- for professionel farmes
42
13. FAQ
Problem Cause Solution
When I put the mink in and step
the pedal the paw is pulled out of
the paw holder? The stretch pressure is too
high or there is dirt in the
slide
Reduce the stretch pressure,
and if it does not help, dismount
the air of the machine, clean an
massage the slide.
The cross-section is not quiet over
the mink, even though I have just
put it in?
The paw holders are mutual
incorrectly adjusted.
Adjust the screws, which are
marked with 2a on figure 2, so
that the line between the two is
quite right.
When I make a triangle cut, the cut
is not deep enough? The spade does not cut
deep enough in the mink. Adjust the depth in vertical data
on the operating panel
When the legs are being loosened,
the skin bursts on the thigh?
The cross cut is laid too far
on the belly side of the legs,
therefore it does not cross
the paw blades.
Too much meat is left on the
thighs by loosening the legs?
The hooks do not close far
enough round or it is
bended. Figure 1- open the hooks a little
bit more with the adjustment
screw
I have opened the hooks, but it
does not help?
Adjust the depth on the hind leg
loosener in the operating panel
(vertical data), they have to be
placed about 3-4 mm under the
thigh holder.
Even though I close the hooks
correctly round the thighs, it does
not loosen well? The hook does not close far
enough round or it is
bended
Try to increase the length and
stroke, so that the balls just pass
each other.
If defect – then change the hook.
The tail spade makes a hole in the
skin when it runs down?
The tail is stretched to hard
out, or there can be a burr
on the side of the spade.
I have closed the tail hook and
want to complete the skin, but the
machine stops?
The signal for completing is
missing, probably because
some dirt is in the lock to
the body holder.
Press reset on the panel, clean
the lock and run the body again
I have cleaned the lock, but still it
does not work?
When you run big minks, it
can happen, that the body
holder do not get far enough
round to lock
Fig. 3 – At repeatable cases, try
to increase the length of stroke
by raising the cylinder 3-4mm
(3a). At the same time lower the
hind leg holder similar.
The tail is not cut up properly?
The tail roll is wrong
adjusted, or it does not get
close enough to the blade.
The blade can be deaf. Check that the tail roll attach can
move unhindered in the length
direction, clean for dirt.
Sharpen the blades if necessary.
I have tried the various
possibilities, but still it does not
work?
Dismount the air of the machine
and check that the tail roll can
reach right to the blades. The tail
roll has to be placed right
beneath the centre of the blades.