Hedensted Gruppen HG Combi Cut, Руководство пользователя

Страница: 20 / 55

Telephone 0045 75891244
- for professionel farmes
20
9 Under the V-cut you lift the tail point to vertical position and you put
the tail into the tail roll (3), and this will pull the tail against the nylon
roll and cut the tail, while the spade runs up with a vertical
movement. Now the tail is cut up. The spade returns to starting
point.
10 The hind leg hooks runs out with a horizontal movement.
11 Step foot pedal. The tail is pulled, so that the cross cut opens up.
You steer with the tail of the mink, so that the back hook is about
75 % free of the hind leg. Step pedal. Then the hook runs down
with a vertical movement and stops with an open hook. Activated
the foot pedal. Next step closes the hook around the thighbone.
12 Activate the foot pedal. Then the tail loosener spade (7) runs with a
horizontal movement. Pull hard in the tail, and the spade runs down
on the back of the mink.
Activate the foot pedal. Back hook closes.
13 Activate foot pedal. Body holder (8) is activated around the mink
and is kept.
14 Paws are clipped (9) or cut – release the mink. (Section 13.3)
15 The tower (10) runs up vertical, at the same time hind leg and tail
are loosened.
16 Body holder returns to starting position, and the mink dumps down
on the conveyor belt.
17 The operator takes a new mink, and the machine returns to starting
position.