7
The spikes must be screwed into the threaded sleeves at the bottom of the box when the silicone
feet have been removed. In order to prevent the floor from being damaged, you should get help
from someone to tilt the box slightly when fitting the spikes.
First, screw in two spikes next to each other and – before setting the box down – put the
corresponding washers (rubber facing down) in place. Then attach the opposite spike and lower
accordingly. Then align the speaker vertically and lock the spikes in place.
CONNECTING YOUR HECO DIREKT EINKLANG LOUDSPEAKERS
Warning: Only hi-fi amplifier loudspeaker outputs may be connected to the loudspeaker terminal.
Please always use a good quality loudspeaker connection cable from an audio dealer. To prevent
impairment of sound quality, we recommend cables with cross-sections of at least 2.5 mm² for
lengths up to 3 m and at least 4 mm² for lengths above 3 m.
Always turn off the amplifier or receiver before connecting or disconnecting loudspeaker cables.
Place the loudspeakers in their planned positions and cut the cables to the right length. The cables
for both channels should always be exactly the same length.
For good sound it is imperative that the cables must be connected in such a way that the speakers
are “in phase”. This means that the black negative terminals on the speakers (-) must be connected
to the negative (-) terminals on the amplifier, the red positive (+) speaker terminals to the positive (+)
amplifier terminals. To make this easier one wire of most speaker cables is marked with a coloured
strip or a ridge in the insulation.
Strip 10 – 15 mm of insulation from the ends of non-ready-made cables. Twist the ends – this is
much better than tinning them with solder – insert them in the terminals and tighten the terminal
screws firmly (Fig. 3).
Before switching on the system double-check all your connections and make sure that the terminal
screws are tight and that there are no short circuits caused by stray wire filaments – this could
cause serious damage to your amplifier!
MAINTENANCE
The lacquered surface is best cleaned with a mild household cleaner. On no account use furniture
polish or similar products on these surfaces.
Содержание DIREKT EINKLANG
