8
WARNING: DO NOT USE THE UNIT IF YOU THINK IT MAY BE FROZEN, AS THIS COULD
RESULT IN SERIOUS DAMAGE TO THE UNIT. WAIT UNTIL YOU ARE SURE
THAT IT HAS COMPLETELY THAWED OUT BEFORE YOU SWITCH ON.
Basin
Check that the power is switched on at the mains isolator switch.
Turn on the hot water tap
FULLY
. If you do not turn the tap on, you will find that the
temperature of the water will vary. The hot water temperature will have been set using the
service valve (diagram 5).
If the unit has been used recently, run the water through for a few seconds to let the
temperature settle down, we advise you DO NOT enter the water flow during this time.
WARNING: YOU MAY INITIALLY GET A SHORT BURST OF VERY HOT WATER
FROM THE UNIT.
If a second tap connected to the unit is also turned on, the hot water will be shared between the
two and so the flow will drop.
When you have finished do not switch off the power if you are going to use the unit again
shortly.
Shower
Check that the power is switched on at the mains local isolator switch.
Turn on the hot (or “flow”) tap
FULLY
(diagram 9).
If the unit has been used recently, run the water through for a few seconds to let the
temperature settle down, we advise you DO NOT enter the water flow during this time.
WARNING: YOU MAY INITIALLY GET A SHORT BURST OF VERY HOT WATER
FROM THE UNIT.
Turn on the cold (or “temperature”) tap, if necessary, to adjust the temperature of the water.
Make sure that no other outlets connected to the unit are used whilst you are in the shower, or
the water flow will drop suddenly.
When you have finished, do not switch off the power if you are going to use the unit again
shortly.
It is important to clean the shower spray plate regularly (see page 7).
In order for the Multiflow to function correctly, the “Heatstore Mixer Kit” must be used.
The kit, Cat No. 3615, comes complete with full accessories including a 3 position
multi-function shower handset.
HOW TO USE YOUR
MULTIFLOW
