Heatmor 400-4S, Руководство пользователя

Страница: 20 / 95

15
CHAPTER 8
INSTALLATION OF THE HEATMOR™ FURNACE
Installation should be performed by a qualified installer and will comply with all the requirements of
the authority having jurisdiction over the installation.
Principles
1) Need to seal the perimeter of the entire HEATMOR™ so rodents are not able to find a home inside
the HEATMOR™.
2) Need to lift the HEATMOR™ without damaging it.
Equipment Required
1) It is not possible to lift a HEATMOR™ with the forks of a forklift under the
HEATMOR™. It
must be lifted from the top
, by the lifting hook. A crane or
heavy backhoe works best, although a heavy duty farm tractor is acceptable.
a) With a farm tractor, extreme care must be taken to prevent the
HEATMOR™ from swinging and causing damage to the HEATMOR™.
Placing the HEATMOR™ on the Concrete Base
2) Before setting the HEATMOR™ onto the concrete base, it is a
good idea to place a solid sheet of the proper “reflective air foil” (also called
bubble foil) between the concrete and the HEATMOR™. This will absorb ridges
in the concrete and make it easier to apply caulking around the inside
perimeter of the base of the HEATMOR™. This reflective foil will also reflect
escaping heat up into the furnace, and help prevent air leaks into the firebox if
cement cracks.
3) Make sure the total area of the HEATMOR™ furnace is on solid concrete.
Do not let the HEATMOR™ extend past the hole in the concrete where the lines come in.
4) After the HEATMOR™ is in place perform the following;
Caulking around the Outside Perimeter of HEATMOR™
a) With a sharp knife, trim any excess bubble foil
that extends past the base of the HEATMOR™.
b) Apply a bead of caulking around the entire outside
perimeter of the HEATMOR™ to seal out rodents.
Lift Hook