Heatmor 200 SSP, Руководство пользователя

Страница: 23 / 80

18
heatMOr’s recOMMenDeD instaLLatiOn instructiOns
Forced Air Heating: If you presently heat with a Forced Air System, you would install a water-to-air heat exchanger
in the ductwork of the furnace according to local codes. Hot water constantly circulates through the exchanger. The
blower, controlled by a thermostat, blows air through the heat exchanger coil and transfers the heat through the house.
A more even heat system is provided with this system. Your existing furnace can stay in place as back-up.
FROM SUPPLY
HEATMOR WATER
TANK
TO RETURN
HEATMOR
WATER
TANK
FILTER
SIDEARM
HEAT EXCHANGER
EXISTING FURNACE
EXISTING WATER HEATER
BLEEDER VALVES
FILTER BYPASS
TEMPERING
VALVE
TEMPERED
WATER TO
HOUSE SYSTEM
COLD
SUPPLY
HOT
SUPPLY
NOTE: WATER COIL IS LOCATED IN THE
OUTLET DUCT OF THE FURNACE IN
ACCORDANCE WITH LOCAL CODES
UL LISTED
MIXING VALVE
TO INNER
PIPE
TO
OUTER
PIPE
FROM
INNER
PIPE
FROM
OUTER
PIPE
Existing Boiler Heating: The Heatmor can be hooked up with an existing boiler as shown. A constant flow of hot water
is maintained through the use of a circulating pump. The zone valves, existing pump and baseboard radiation transfer the
heat through the house. The old system can then remain as the back-up.
FROM SUPPLY
HEATMOR WATER
TANK
SIDEARM
EXISTING BOILER
EXISTING WATER HEATER
BLEEDER VALVES
TEMPERING
VALVE
TEMPERED
WATER TO
HOUSE SYSTEM
COLD
SUPPLY
HOT
SUPPLY
NOTE: WATER COIL IS LOCATED IN THE
OUTLET DUCT OF THE FURNACE IN
ACCORDANCE WITH LOCAL CODES
UL LISTED
MIXING VALVE
TO INNER
PIPE
TO
OUTER
PIPE
FROM
INNER
PIPE
FROM
OUTER
PIPE
CIRCULATING
PUMP
SUPPLY TO
EXISTING
HEATING
EXISTING
PUMP
UNION
RETURN FROM
EXISTING HEAT
UNION
WATER TO
WATER
HEAT
EXCHANGER
UNION
UNION
TO RETURN
HEATMOR
WATER
TANK