21
saFe Furnace OPeratiOn GuiDeLines
OPERATION
heatMOr™ OutDOOr Furnace 200 ssP is certiFieD tO Burn WOOD PeLLets OnLY.
Burning of other materials may result in serious burns, health consequences, or damage to this furnace and
other components of the heating system and may void warranty.
***iMPOrtant nOtice***
PLEASE REFER TO “LIGHTING THE HEATMOR™ FOR THE FIRST TIME” AND “LOADING WOOD
PELLETS INTO THE HEATMOR™”, FOR ADDITIONAL SAFE LOADING PROCEDURES.
1) Never open the firebox door if the combustion air blower is operating or if you suspect a roaring
hot fire inside the firebox.
2) Never open the firebox door immediately after the combustion air blower has shut off. If the water
temperature is very close to the high setting, you should assume the air combustion fan has
just shut off.
3) If there is more than a “wiff” of exhaust coming from the chimney and the draft fan is off, do not
open the firebox door for at least two minutes. The burn cycle would have just ended and the firebox
will be full of unburned gases (exhaust) that may ignite when fresh air is introduced.
4) Load the unit with wood pellets carefully. After loading wood pellets make sure all debris is cleaned
from the hopper door. Then close hopper door securely.
5) Keep the firebox door, ash pan cover plate, all three flue cover plates, hopper door, airbox cover
plate and the outer doors of the HEATMOR™ furnace closed at all times except for servicing and
refueling.
6) Keep the locking handle on the outer doors locked at all times when not servicing or refueling to
reduce the risk of tampering and possible injury.
7) Never add water to the HEATMOR™ furnace if the internal water temperature is over 212 degrees
Fahrenheit. Failure to adhere to this warning may cause a steam flash and result in an explosion.
8) Do not store combustible liquids or materials near the outdoor furnace. Adhere to the “Clearance to
Combustibles” guidelines.
9) Never use gasoline, kerosene, charcoal, lighter fluid or similar liquids to start, re-start or
freshen up a fire. Using such liquids may result in severe burns and injury.
10) When adding water, water treatment or loading or maintaining the HEATMOR™ furnace, protective
clothing must be worn at all times.
chaPter 8
Содержание 200 SSP
