01/04
35593 Rev G
13
CALIBER DESIGNER DIRECT VENT
5. Rear Venting
Remove the back cover plate, outer cover plate and
inner cover plate by removing the screws. Place the 5
inner collar onto the appliance with the screws removed
from the cover plates. Attach the 8 outer collar to the
appliance top using the screws removed. Make sure
that the gaskets for the outer collars seal tightly. Place
the 12 top cover plate with an 8 hole over the outer
collar and secure with the screws removed. Place the
insulated top cover plate without the 8 hole on the top
of the appliance and secure. See Figures 16-17.
Figure 16
WARNING!
If not sealed, a fire hazard will be created and
the appliance will not operate properly.
6. Top Venting
Remove the outer cover plate, then the inner cover
plate by removing the screws. Place the 5 inner collar
into the appliance with the screws removed from the
cover plate. Attach the 8 outer collar to the appliance
top using the screws removed. Make sure that the
gaskets for the outer collars seal tightly. Place the 12
insulated top cover plate with an 8 hole over the outer
collar and secure. See Figure 18.
Figure 18
Placement of Inner and Outer Collars
Figure 17
