3
200068-01
tESt anD aDJuStMEnt
NOTE: Sensor has a 2 minute warm up period before
it will detect motion. When switching modes wait 2
minutes.
1. Slide the sensor switch to the TEST position.
2. Place the RANGE adjustment in the medium position
(halfway between MIN and MAX position).
Least Sensitive
Most Sensitive
Sensor
Motion
70 ft.
(21 m)
8 ft.
(2.4 m)
Maximum Range
Maximum
Coverage Angle
MAX
MIN
RANGE
ON-TIME
TEST 1 5 OFF
MINUTES
Bottom of Sensor
Aim Sensor Down for
Short Coverage
Aim Sensor Higher for
Long Coverage
Ball Joint
Red LED Indicator
Clamp Screw
adjustment of Coverage area
The sensor detects “motion” by the movement of heat
(body heat) across the coverage area. However, following
are examples of objects that also produce heat and can
cause the sensor to false trigger:
• Pools of Water
• Air Conditioners
• Dryer Vents
• Fenced-In Animals
• Heating Vents
• Automobile Traffic
If you suspect that a heat source of this type is falsely
triggering the sensor, try reducing the RANGE or aiming
the sensor away from the heat source in question.
Note: The detector is less sensitive to motion directly
towards it and more sensitive to across motion.
Motion
OPEratIOn
Place the sensor switch in the 1 or 5 minute mode for
normal operation. If the light is not needed, put the switch
in the OFF position.
Mode:
On-Time
Works:
Day
Night
test
5 Seconds
x
x
auto
1 or 5 Minutes
x
3. Loosen the clamp screw in the sensor ball joint.
4. Walk through the coverage area noting when the lights
turn on. Gently move the sensor head up, down, or
sideways to change the coverage area. Note: Wait 5
to 10 seconds after light turns off to retest.
5. Increase RANGE only as needed. A higher RANGE
setting may cause false triggering and reduce battery
life.
6. Secure the sensor into position by tightening the clamp
screw. Do not overtighten the screw.
7. After dark, loosen the light joint clamps and adjust the
light to cover desired area. Tighten joint clamps when
desired area is covered.
180°
IMPORTANT:
To conserve battery power, this light has
an automatic dimming feature when using the 5 minute
setting. After all motion has stopped, the light will remain
full bright for 2
1
/
2
minutes. After 2
1
/
2
minutes, the light
will dim to about 1/3 power for the remainder of the 5
minute timer.
