27
Heat & Glo • FDN-4-SS, FDN-5-SS, FDN-6-SS, FDN-7-SS Installation Manual • 16400-9800 Rev. H • 11/19
I. WALL TERMINATION - WITH AND WITHOUT OPTIONAL DAMPER
8 - VENTING
USE HEAVY DUTY FASTENERS
APPROPRIATE
TO YOUR CONSTRUCTION TO
SECURE POWERVENT
DRILL 1/4” HOLES
TO MATCH POWER VENT BASE
OPTIONAL MECHANICAL
FLUE DAMPER
INSULATION PAD MUST BE CUT IN
CENTER TO ACCOMMODATE VENT SIZE.
PLACE FOIL SIDE OUT.
ACCESS PANEL NEEDED FOR DAMPER MOTOR SERVICE
Minimum recommended size for ease of access is 11 inches wide x 8 inches deep.
Figure 8I.2
INSULATION PAD MUST BE CUT IN
CENTER TO ACCOMMODATE VENT SIZE.
PLACE FOIL SIDE OUT.
USE HEAVY DUTY FASTENERS
APPROPRIATE
TO YOUR CONSTRUCTION TO
SECURE POWERVENT
DRILL 1/4” HOLES
TO MATCH POWER
VENT BASE
FRAMING:
8" = 11-3/4" W X 11-3/4" H
10" = 13-1/4" W X 13-1/4" H
Wall Termination With
Optional Mechanical Damper
Wall Termination Without
Optional Mechanical Damper
W
H
OPTIONAL
Figure 8I.1
