
14
T32FNA
Arrangement of the screws [
-
] on the flange:
T32 FNA 50Nm ... 200Nm
T32 FNA 500Nm ... 2 kNm
T32 FNA 10 kNm ... 25 kNm
3.3.1 Mounting with curved tooth couplings
Selfcentering curved tooth couplings made by Messrs. Tacke are proved in
combination with HBM torque transducers. They are torsionally stiff and take
care of the introduction even of dynamic torque to the torque transducer in the
correct way. In addition, angular displacement and parallel or axial shift are
compensated with small restoring force.
HBM can supply suitable couplings that are well matched to the type of torque
transducer and the intended use. Special requirements of the customer are
taken care of and the shaft connections are made to the specified dimensions.
The torque transducer and the coupling housing are assembled at HBM and
are dynamically balanced (balancing quality level G 2.5). Therefore, the
mounted assembly should not be disassembled again. If this cannot be
avoided one should mark all parts in such a way that they can be assembled
afterwards in exactly the same way. Upon reassembly, the original balancing
quality can only be obtained by renewed balancing.
Coupling hubs are balanced individually and the keyways are made after ba-
lancing. Further information will be found in the various data sheets provided
by HBM.
SUNSTAR传感与控制 http://www.sensor-ic.com/ TEL:0755-83376549 FAX:0755-83376182 E-MAIL:[email protected]
SUNSTAR自动化 http://www.sensor-ic.com/ TEL: 0755-83376489 FAX:0755-83376182 E-MAIL:[email protected]