[
+49 (0) 21 91 / 7 920 •
\
+49 (0) 21 91 / 7 92375 •
^
hazet.de •
]
3
Design and function
Performing the test
1. The indicator lamp lights up red in standby
mode. Press the power button to heat the
brake fluid and keep it pressed until the test
is complete. It takes about 19 to 30 seconds.
2. During the heating process, the LED flashes GREEN and the display (right) moves.
3. The tester emits a short beep after the test is completed. The result
of the boiling point temperature is shown on the LCD display.
4. The indicator lamp lights up yellow when the test is completed.
Wait until the light is red before starting the test again.
Display of operational failures
E-1: means there is no or insufficient fluid
Notes
!
If the tester is used without touching the fluid, "E1" is displayed and the heating
process is stopped. This is the security measure used to protect the tester.
"
The indicator lamp lights up yellow and emits a longer beep.
§
Release the power button. TEMP> 320 °C / 608 °F fades out and only "E1" is
displayed. After approx. 1 minute, the display automatically fades out on the screen.
$
Reconnect the battery in order to use the tester again.
If the problem persists, please contact our service center.
Electrical energy may cause serious injuries!
Always wear personal protective equipment!
