[
+49 (0) 21 91 / 7 92-0 •
\
+49 (0) 21 91 / 7 92-375 •
^
hazet.de •
]
3
Design and function
Precautions and warning indications
1. Use the car battery for the power source.
2. First connect the negative terminal () and then the positive terminal (+).
3. Never use the tester without fluid!
4. Do not press the power button if the probe is not
submerged to the required fluid level.
5. Make sure the fluid level does not exceed the position TO THE LINE during the test.
If an abnormal situation comes up during the test, terminate the battery connection
immediately.
6. Use the supplied test container to get accurate test results.
Testing directly on the vehicle is also permissible if there is space.
7. Clean the tester before each test. Cleaning: When the test is complete, allow the
rest of the brake fluid to drip off the probe, wash it with clean water and wipe it
dry. Do not dip the probe into water over the "To The Line" marking. Wipe the test
container and syringe dry and carefully place them back into the supplied case.
Instructions
Voltage detection
1. Make sure the battery voltage
is 12 V.
2. Connect the battery connection cable as
described above with the car battery.
12V
+
-
Electrical energy may cause serious injuries!
Always wear personal protective equipment!
