Hawking Net-Vision HNC290G, Быстрое руководство по установке

Страница: 11 / 36

11
Each available camera will be displayed in the camera list
with its MAC address, current
default or configured IP
address, and model number. (NOTE: The Setup Wizard may
display an IP address for the new camera that is already
consistent with your local area network [LAN] settings, rather
than the default one.) In the camera list, click on the camera
you would like to configure so that it is highlighted blue, and
then click
Next . (If you are unsure about which camera you
would like to configure, you can compare a camera’s MAC
address in the camera list with the one printed on the label on
the underside of the camera.)
NOTE: If the camera list does not display any available
cameras, you should:
a. Click on the “Rescan Camera” button, and
b. Make sure that all available similar network cameras are
connected properly to the network.
If neither option above is successful, you can also perform a
factory default reset on the camera by holding down the
“Reset” button on its back panel for at least five seconds .
Then, allow about 45 seconds to one minute for the camera to
complete the reboot process. This should resolve the issue.