87
Aggregation Size:
The Aggregation Size is in the range of 1024~65535, default is 50000. It
determines the size (in Bytes) of the larger frame.
5-2 Advanced Settings
The administrator can change the Slot Time, ACK Timeout, RTS threshold and fragmentation threshold
settings for the system
Beacon Interval:
Beacon Interval is in the range of 40~3500 and set in unit of millisecond. The
default value is 100 msec. Access Point (AP) in IEEE 802.11 will send out a special
approximated 50-byte frame, called “Beacon”. Beacon is broadcast to all the
stations, provides the basic information of AP such as SSID, channel, encryption
keys, signal strength, time stamp, support data rate. All the radio stations
received beacon recognizes the existence of such AP, and may proceed to the
next actions if the information from AP matches the requirement. Beacon is sent
on a periodic basis. The time interval can be adjusted. By increasing the beacon
interval, you can reduce the number of beacons and associated overhead, but
that will likely delay the association and roaming process because stations
scanning for available access points may miss the beacons. You can decrease the
beacon interval, which increases the rate of beacons. This will make the
association and roaming process very responsive; however, the network will
incur additional overhead and throughput will go down.
DTIM Interval:
The DTIM interval is in the range of 1~255. The default is 1. DTIM is defined as
Delivery Traffic Indication Message. It is used to notify the wireless stations,
Содержание HPOW5CM
Страница 21: ...20...
Страница 50: ...49 Settings can be modified via the VLAN setup after configuration is complete See section 4 3...
Страница 126: ...125...