HATO SWING 400, Руководство по сборке и эксплуатации

Страница: 12 / 36

DEVICE DESCRIPTION
PURPOSE
The HELB9C controller is designed for gate drives using two 230Vac motors /
actuators with a power of up to 500W. Perfect for private properties and companies. The
applied system of variable coding of Microchip transmitters makes the system inaccessible to
an unauthorized person.
CONTROLLER ADVANTAGES
•
Soft start and stop, which increases the life of the door.
•
Controlled by transmitters with dynamic Keeloq code.
•
Control on bell buttons.
•
Functions: AUTO-CLOSING, OPEN ONLY, WICKET (opening one leaf).
•
Adjustment of the pulling force.
•
Working time adjustment.
•
Slowdown function.
•
SOFT START function (from version B9: 1.x.x / 1.3.x / P: x.x.x).
•
Operation in single-leaf mode (from version B9: 1.x.x / 1.7.x / P: x.x.x).
•
Traffic lights.
•
The function of shortening the auto-closing time after detecting a passage.
•
Possibility to install an infrared barrier.
•
Test function for photocells to increase safety.
•
Possibility to connect an electric lock.
•
Signaling the status of inputs.
•
Remote programming of transmitters in eLB9E and eLB9Ek versions.
•
Simple installation and programming procedure.
MODE OF ACTION
The drive is controlled by the transmitter button programmed in HELB9 or by bell
buttons: SBS sequence control, WI door control and STOP stop. In the case of control from
the SBS input and the transmitter assigned to this function, the operation consists in carrying
out the step-by-step commands OPEN-STOP-CLOSE-STOP or with the ONLY OPEN
function enabled, it is only possible to open the gate. After turning on the power, the first
command is to open, if we give the next command while the gate is moving, we will stop it,
and then we can run it in the closing direction. The Wicket function (opening one M1 leaf) is
controlled from the WI input and / or from the transmitter button assigned to this function.
After switching the power supply on, after the first control
signal, the motors are switched on for the full time of operation.
Synchronization of the settings takes place after reaching the end
positions of the mechanical stops.
If the gate is not synchronized, the motor, after reaching the
limiter, despite the fact that the gate is not moving, may still be on
for some time (maximum for the programmed operating time) - you
must wait until the controller turns off the motors (the signal light
goes out, you hear the shutdown) relays) and only then can the drive
be restarted. In the absence of power supply, it is recommended to
12