Form No. GR3SDSCTM-1119
9
English
MAINTENANCE
General
Glo-Ray
®
Heated Glass Merchandisers are designed
for maximum durability and performance with minimum
maintenance.
WARNING
ELECTRIC SHOCK HAZARD:
• Turn OFF power switches, unplug power cord(s), and
allow unit to cool before performing any cleaning,
adjustments, or maintenance.
• This unit has one or two power cords. Disconnect
ALL power supply cords before performing any
maintenance or cleaning.
• Do not submerge or saturate with water. Unit is not
waterproof. Do not operate if unit has been submerged
or saturated with water.
• Do not steam clean or use excessive water on unit.
• This unit is not “jet-proof” construction. Do not use
jet-clean spray to clean this unit.
• Do not clean unit when it is energized or hot.
This unit has no “user-serviceable” parts. If service
is required on this unit, contact an Authorized Hatco
Service Agent or contact the Hatco Service Department at
800-558-0607 or 414-671-6350.
Use only Genuine Hatco Replacement Parts when service
is required. Failure to use Genuine Hatco Replacement
Parts may subject operators of the equipment to
hazardous electrical voltage, resulting in electrical shock
or burn. Genuine Hatco Replacement Parts are specified
to operate safely in the environments in which they are
used. Some aftermarket or generic replacement parts do
not have the characteristics that will allow them to operate
safely in Hatco equipment.
Daily Cleaning
To preserve the finish of the unit as well as maintain
performance, it is recommended that the unit be cleaned daily.
NOTICE
Use non-abrasive cleaners only. Abrasive cleaners could
scratch the finish of the unit, marring its appearance and
making it susceptible to soil accumulation.
1. Turn off the unit, unplug the power cord(s), and allow the
unit to cool.
2. Remove all food containers.
3. Wipe down the hardcoated heated base and all metal
surfaces using a clean, damp cloth. Stubborn stains may
be removed with a good non-abrasive cleaner. Hard to
reach areas should be cleaned with a small brush and mild
soap.
4. Clean the heated glass shelves and glass side panels
using ordinary glass cleaner and a soft cloth or paper
towel.
5. Wipe dry all metal surfaces using a clean, dry cloth
Ground Fault Circuit Interrupters
Heated Glass Merchandisers are supplied with one or two,
built-in Ground Fault Circuit Interrupters (GFCI)—one for each
circuit. GFCIs are designed to turn off electrical power and help
prevent damage to the internal components when there is a
short circuit or electrical fault.
To reset a GFCI:
1. Make sure the unit is plugged in and all I/O (on/off) switches
are in the
I
(on) position.
2. Push the RESET button.
NOTE: The unit must be plugged in and turned on for the GFCI
to reset. If the unit is off, the GFCI will not reset.
If a GFCI continues to trip, contact an Authorized Hatco Service
Agency.
RESET
Button
Ground Fault
Circuit Interrupters
Ground Fault Circuit Interrupters
Содержание Glo-Ray GR3SDS-27DCT
Страница 23: ...Form No GR3SDSCTM 1119 23 English NOTES NOTA...