HARTING Ha-VIS RF-R500, Инструкция по сборке

Страница: 16 / 64

8
HARTING Electric GmbH
Ha-VIS RF-R500 - Assembly Manual
English
Depending on the cable cross-section the following cable distances can be used.
Cable cross-section (Cat. 5 ... 7) Maximum cable length for PoE
0.4 mm ≈ 30 m
0.6 mm ≈ 70 m
Table 7 Maximum cable length if PoE is used
3.2.2 Ethernet-Interface on X2 (10/100Tbase)
The Reader has an integrated 10/100Base-T network port for an RJ45. Connection is made on
X2 and has an automatic “Crossover Detection” according to the 100Base-T Standard.
With structured cabling Cat. 5 cables should be used. This ensures a reliable operation at
10 Mbps or 100 Mbps.
The prerequisite for using TCP/IP protocol is that each device has a unique address on the
network. All Readers have a factory set IP address.
Network Address
IP address 192.168.10.10
Subnet-Mask 255.255.255.0
Port 10001
DHCP AUS
Table 8 Standard factory configuration of the Ethernet connection
Note
The Reader includes a DHCP-able TCP/IP interface.
3.2.3 USB-Interface X3 (Host Communication)
The USB socket on the board is terminal X3. The pinout is standardized. The data rate is
reduced to 12 Mbit (USB full speed). A standard USB-cable can be used.
Figure 6 USB-Interface for host communication
Note
The length of the USB-cable can be a max. of 5 m (20 inch). It is not allowed to use longer
cables.